3.2Alloy families
Six families. Grades named the way your specification names them.
Designations below are those listed by the manufacturer. Material standards referenced include GB, ASTM, AISI, EN, DIN, BS, JIS, NF, AS, AAR. The grade and governing standard are confirmed in every quotation.
Duplex
The workhorse for rotating separation equipment. Compared with austenitic grades, the manufacturer points to higher strength and better resistance to intergranular and chloride stress corrosion; compared with ferritic grades, higher toughness and better weldability.
- 2205 · EN 1.4462 · UNS S32205 / S31803
- 2304 · EN 1.4362 · UNS S32304
- 2101
- S32003
Super duplex
For chloride-rich and sea-water duty where pitting resistance has to go further. Poured from AOD-refined melts with very low carbon, phosphorus and sulphur.
- 2507 · EN 1.4410 · UNS S32750
- S32707
- S32760
Austenitic
Standard and low-carbon austenitic grades for general corrosive service, widely used for bowls, scrolls, pipes and valve castings.
- 304 / 304L
- 316 / 316L
- 904L
- 347
Martensitic and PH
Hardenable stainless steels for end hubs, roll shells and structural parts where strength and wear resistance lead the specification.
- CA15
- AISI 410
- AISI 431
- EN 1.4418
- 17-4PH
Heat-resistant
Steels for hot-section turbine casings, gratings and furnace-side parts, matched to the temperature zone the component works in.
Nickel-based
Nickel-based and high-nickel alloys for the most aggressive media and for hot gas paths. The manufacturer cites more than 30 nickel alloys in its portfolio.
- Ni-Cr-Mo alloys
- Hastelloy alloys
- CN7M